Dogbone Create Gadget

This gadget creates a set of vectors which can be used to profile along to create a filleted toolpath of the selected vectors. The gadget is to be used in conjuction with the 'Dogbone Detect' gadget. To use the two gadgets to create an automatically filleted outside profile vector do the following:

1. Select the vectors you want filleting.
2. Run the 'Dogbone Detect' gadget to create markers for where fillets will be placed
3. Delete any markers which indicate places which you do not wish to be filleted.
4. Run The 'Dogbone Create' gadget
5. Choose the diameter of the tool and the interior and exterior allowances. These should match those given by the 'Dogbone Detect' gadget and are automatically filled in.
6. Set the Marker layer name so it matches the name of the layer on which markers are placed. Again, this is automatically filled when the detection gadget has just been run.
7. Choose a name for the layer on which your new profile vector is placed.